AS1462-6-2008 国外国际规范.pdfVIP

1 AS/NZS 1462.6:2008 Australian/New Zealand StandardTM A S / N Z Methods of test for plastics pipes and fittings S 1 4 6 2 6. Method 6: Thermoplastics pipes, fittings and : 2 0 0 assemblies for the transport of fluids under 8 pressure—Resistance to internal pressure PREFACE This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee PL-045, Plastics Pipe Systems Test and Calculations. This Standard is based on ISO 1167-1, Thermoplastics pipes, fittings and assemblies for the conveyance of fluids— Determination of the resistance to internal pressure , Part 1: General method, ISO 1167-2, Thermoplastics pipes, fittings and assemblies for the conveyance of fluids—Determination of the resistance to internal pressure, Part 2: Preparation of pipe test pieces , ISO 1167-3, Thermoplastics pipes, fittings and assemblies for the conveyance of fluids—Determination of the resistance to internal pressure, Part 3: Preparation of components , and ISO 1167-4, Thermoplastics pipes, fittings and assemblies for the conveyance of fluids—Determination of the resistance to internal pressure, Part 4: Preparation of assemblies, and replaces the following Standards: AS/NZS 1462 Methods of test for plastics pipes and fittings 1462.6 Part 6: Method for hydrostatic pressure testing of pipes AS 1462.9 Part 9: Method for hydrosta