AS1462-8-2008 国外国际规范.pdfVIP

1 AS/NZS 1462.8:2008 Australian/New Zealand StandardTM A S / N Z Methods of test for plastics pipes and fittings S 1 4 6 2 8. Method 8: Method of testing the leaktightness of : 2 0 0 assemblies 8 METHOD 1 SCOPE This Standard specifies a method for testing the leaktightness of assemblies of plastics pipes and fittings with elastomeric sealing-ring socket joints or inspection openings that may be subject to diametric distortion and/or angular deflection. It includes, but is not limited to— (a) single sockets on pipes, (b) double sockets, (c) sockets on fittings, and (d) inspection openings on fittings. It is also applicable to elastomeric sealing-ring sockets made of other materials, e.g. ductile iron, intended for use with plastics piping. 2 PRINCIPLE A joint assembly, such as a test piece consisting of a plastics pipe mounted into an elastomeric seal socket, is subjected, within a specified temperature range, to a specified internal positive or negative pressure regime for a specified test period during which the pipe may also be subject to an angular deflection and/or diametric distortion. While under 8 pressure (positive or negative), the test piece is monitored for signs of leakage. 0 0 2 p e 3 SYMBOLS AND DEFINITIONS S 3 2 n