AS4747.5-2008 国外国际规范.pdfVIP

ATS 4747.5—2008 A T S 4 7 4 7 . 5 — 2 0 0 8 Australian Technical Specification Meters for non-urban water supply Part 5: Installation and commissioning of closed conduit meters fully charged 8 0 0 2 l u J 3 1 n o A I L A R T S U A H T U O S F O Y T I S R E V I N U y b d e s s e c c A This Australian Technical Specification was prepared by Committee CE-024, Measurement of Water Flow in Open Channels and Closed Conduits. It was approved on behalf of the Council of Standards Australia on 6 May 2008. This Technical Specification was published on 30 June 2008. The following are represented on Committee CE-024: • Australian Industry Group • Department of Natural Resources and Water, Qld • Institute of Instrumentation, Control and Automation Australia • Irrigation Australia • National Measurement Institute • NSW Department of Commerce • University of South Australia • Water and Wastewater Association of Australia Standards Australia wishes to acknowledge the participation of the expert individuals that contributed to the development of this Technical Specificatio