Rokeby发电站通过使用Liqui-Cel® 14x28 膜组件去除CO2，扩展混合床式树脂的寿命，节省资本费用50%.pdf

Rokeby Generating Station Saves 50% in Capital Expense by Using Liqui-Cel® 14x28 Membrane Contactors to Remove CO2 to Extend Mixed Bed Resin Life Lincoln Electric Systems (LES) recently commissioned a membrane decarbonation system using Liqui-Cel® 14x28 Membrane Contactors to remove CO2 prior to their mixed bed deionizers. The system was installed at the Rokeby Generating Station (RGS) in Lincoln, Nebraska. Background The Rokeby Generating Station is LES’ primary peaking power station, totaling 255 MW and consisting of 3 duel fuel combustion turbines. The existing DI water system consisted of two single-pass, two-stage RO skids followed by a 31 ft3 3 (0.87 m ) mixed bed deionizer and two 250,000-gallon (943 m3) storage tanks. LES determined that the mixed bed unit was producing only 30% of its expected capacity (90,000 gallons actual vs. 300,000 gallons expected or 341 m3 actual vs. 1136 m3 expected). It was determined that the cause of the decreased capacity was due to dissolved CO2 in the water, which was overloading the anion resin. As the power capacity demand increased, LES had to act quickly to update their winter contingency plans. System Design In 2005, LES began engineering a membrane Treatment Options decarbonation system using Liqui-Cel 14x28 Multiple treatment options including chemical Membrane Degasifiers. The system was designed treatment and the installation of a forced draft to treat the combined water flow from both RO degasifier were considered. Ultimately, chemical skids, approximately 150 GPM (0.6 m3). The goal treatment was considered too risky because of was to achieve approximately 90% reduction of its negative impact on increasing scale on the dissolved CO2. Add