五年发展战略规划书范文PDF打印版.pdfVIP

学 海 无 涯 XX 有限公司 五 年 发 展 战 略 规 划 书 （规划时限：XXXX 年-XXXX 年） 编订时间： XXXX 年 月 实施时间： XXXX 年 月 目 录 一、规划总则 （一）规则编制背景 （二）规则指导思想及原则 （三）规划时限 二、公司概况 三、企业战略环境分析 （一）企业经营环境分析 （二）现有竞争对手的分析 （三）客户力量的分析 （四）供应商力量的分析 （五）企业现状分析 四、企业总体战略规划 爱意播撒在这青山绿水，让这份爱生根发芽，承载起贫瘠山村的绿色希年来，支月英坚守岗位，把be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe望。Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or lessshall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness:diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position shouldcompensator lengthen should conform to the requirements in the following table: square scale lengthδx is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valvebelow the horizontal parts.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents;2) supports and hangers of ma