HART375升级指南[共7页].pdfVIP

VERSION 3.0 UPGRADE PROCEDURE August 2009 www.FieldC UPGRADE PROCEDURE Instructions for Upgrading the 375 Field Communicator to Version 3.0 Important – Read the following Overview and Prerequisites before proceeding with the upgrade instructions. Overview There are three steps to upgrade your 375 Field Communicator to the Version 3.0 System Software. Step 1: Use the new Easy Upgrade Utility (3.0) to upgrade to Version 3.0 System Software on the Field Communicator System Card. This requires a Secure Digital card reader. Step 2: Insert the upgraded System Card into the 375 Field Communicator to upgrade the 375 Field Communicator. Step 3: Register the 375 Field Communicator. Prerequisites (Verify the following before proceeding) • The 375 Field Communicator contains System Software Version 2.5 or earlier. • A Secure Digital (SD) card reader is installed or connected to your PC. • Understand that any HART configurations stored in the flash memory of the 375 Field Communicator ® will be lost after the upgrade unless they are first saved on either an Expansion Module or in AMS Suite: Intelligent Device Manager. • If the 375 Field Communicator has an Expansion Module installed in the side of the 375, remove it before performing the upgrade. It can be re-inserted when the upgrade is complete. © 2009, Emerson Process Management Resource CD Install (version 1.2) Page 2 of 7 August 2009 www.FieldC UPGRADE PROCEDURE STEP 1: Upgrade the System Card 1.1 Open the Easy Upgrade Utility by selecting Start | All Programs | Field Co