塑料电镀原理与工艺介绍120130308.ppt

Anodes High grade phosphorized copper anode material such as CU-PHOS or AMPHOS 40, both available from Atotech, should be used. Titanium hooks or baskets are recommended. Other types of anode materials may offer problems of excessive polarization, roughness, high additive consumption or other undesirable effects. Phosphorized rolled copper anodes or phosphorized slugs in titanium baskets are recommended for acid copper plating solutions. Typically, the anodes contain between 0.02 and 0.06% phosphorus. Anodes should be 3-5 inches shorter than the longest rack being plated because a large amount of anode area below the rack will concentrate current on the bottom racked parts, yielding burns or dull plating. A well operating anode typically has a dark, black slime on the surface. The presence of a copper or slightly grayish surface, is an indication of high chloride (as shown in the photo) Anodes High grade phosphorized copper anode material such as CU-PHOS or AMPHOS 40, both available from Atotech, should be used. Titanium hooks or baskets are recommended. Other types of anode materials may offer problems of excessive polarization, roughness, high additive consumption or other undesirable effects. Phosphorized rolled copper anodes or phosphorized slugs in titanium baskets are recommended for acid copper plating solutions. Typically, the anodes contain between 0.02 and 0.06% phosphorus. Anodes should be 3-5 inches shorter than the longest rack being plated because a large amount of anode area below the rack will concentrate current on the bottom racked parts, yielding burns or dull plating. A well operating anode typically has a dark, black slime on the surface. The presence of a copper or slightly grayish surface, is an indication of high chloride (as shown in the photo) Anode Bags Loosely fitted polypropylene or Dynel anode bags are recommended. The loose fit is important to allow transfer of dissolved copper from inside the bag to the bulk of the plating