320C调节器的校准（卡特挖掘机资料）.pdfVIP

320C 320C L Excavators BPR00001-UP (MACHINE) POWERED BY 3066 Engi... 页码，7/17 S/N - TBR1-UP S/N - XJA1-UP S/N - Y4P1-UP Note: The 325C, M325C MH, and 330C series does not have a governor actuator. This function can memorize the rotation angle of the governor actuator and the no- load engine speed. This information is saved into the controller after the accelerator cable of the governor actuator has been replaced, installed and/or adjusted. The controller will use the information that was saved in order to determine the target position for the actuation of the governor actuator. Note: Ensure that the calibration procedure for the governor actuator is performed when the governor actuator, the accelerator cable or the controller has been replaced or installed. The temperature of the hydraulic oil should be 50 °C (122 °F) prior to the calibration. Illustration 1 The above illustration is an example of the display for the 312C. All of the other displays are identical with the sales model on the fourth line. 1. Enter the service mode. /sisweb/sisweb/techdoc/techdoc_print_page.jsp?retu... 2012-9-23 320C 320C L Excavators BPR00001-UP (MACHINE) POWERED BY 3066 Engi... 页码，8/17 Illustration 2 2. Highlight the second line of the display and use the direction for direction to scroll through the display. Scroll through the display until the display shows CALIBRATION. Illustration 3 3. Highlight the third line by using the keys for direction. The name of the device will be shown on the third line. Scroll downward until STANDBY is highlighted. Press the OK key in order to start the calibration procedure. /sisweb/sisweb/techdoc/techdoc_print_page.jsp?retu... 20