英国石油公司（BP）标准 GS 134-1 Hydraulic Power Supplies.doc

GS 134-1 HYDRAULIC POWER SUPPLIES November 1993 Copyright ? The British Petroleum Company p.l.c.  Copyright ? The British Petroleum Company p.l.c. All rights reserved. The information contained in this document is subject to the terms and conditions of the agreement or contract under which the document was supplied to the recipients organisation. None of the information contained in this document shall be disclosed outside the recipients own organisation without the prior written permission of Manager, Standards, BP International Limited, unless the terms of such agreement or contract expressly allow.  BP GROUP RECOMMENDED PRACTICES AND SPECIFICATIONS FOR ENGINEERING Issue Date November 1993 Doc. No. GS 134-1 Latest Amendment Date Doc. No. RP 32-5 Document Title HYDRAULIC POWER SUPPLIES (Replaces BP Engineering Standard 115) APPLICABILITY Regional Applicability: International SCOPE AND PURPOSE This Specification is for Hydraulic Power Supplies and applies to closed and open loop systems using either mineral oil, fire resistant, or water based fluids as the power transmission medium. Its purpose is for the specification of fit for purpose Hydraulic Power Supplies at minimum cost. AMENDMENTS Amd Date Page(s) Description ___________________________________________________________________ CUSTODIAN (See Quarterly Status List for Contact) Electrical Engineering Issued by:- Engineering Practices Group, BP International Limited, Research Engineering Centre Chertsey Road, Sunbury-on-Thames, Middlesex Tel: +44 1932 76 4067 Fax: +44 1932 76 4077 Telex: 296041 GS 134-1 HYDRAULIC POWER SUPPLIES PAGE page iv CONTENTS toc \oFOREWORD ii 1. INTRODUCTION 1 1.1 Scope 1 1.2 Quality Assurance 1 2. GENERAL REQUIREMENTS 1 3. SAFETY 1 3.1 General 1 3.2 Noise 2 3.3 Isolation 2 3.4 Emergency Stop 2 3.5 Over-Pressure Protection 2 3.6 Hazardous Areas 3 3.7 Failure Modes and Effects Analysis (FMEA) 3 4. DESIGN REQUIREMENTS 3 4.1 General 3 4.2 Maintainabili