51单片机的串口通信程序[规整].pdfVIP

单片机串口通信程序 #include reg52.h #includeintrins.h #include stdio.h #include math.h #define uchar unsigned char #define uint unsigned int sbit Key1 = P2^3; sbit Key2 = P2^2; sbit Key3 = P2^1; sbit Key4 = P2^0; sbit BELL = P3^6; sbit CONNECT = P3^7; unsigned int Key1_flag = 0; unsigned int Key2_flag = 0; unsigned int Key3_flag = 0; unsigned int Key4_flag = 0; unsigned char b; unsigned char code Num[21]={0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80, 0x90,0x40,0x79,0x24,0x30,0x19,0x12,0x02,0x78,0x00, 0x10,0x89}; unsigned char code Disdigit[4] = {0x7F,0xBF,0xDF,0xEF}; unsigned char Disbuf[4]; void delayms(uint t) { uint i; while(t--) { /* 对于 11.0592M 时钟，约延时 1ms */ for (i=0;i125;i++) {} } } // void SendData(uchar Dat) { uchar i=0; SBUF = Dat; while (1) { if(TI) 1 / 5 { TI=0; break; } } } void ScanKey() { if(Key1 == 0) { delayms(100); if(Key1 == 0) { Key1_flag = 1; Key2_flag = 0; Key3_flag = 0; Key4_flag = 0; Key1 = 1; } else; } if(Key2 == 0) { delayms(100); if(Key2 == 0) { Key2_flag = 1; Key1_flag = 0; Key3_flag = 0; Key4_flag = 0; Key2 = 1; } else; } if(Key3 == 0) { delayms(50); if(Key3 == 0) { Key3_flag = 1; Key1_flag = 0; Key2_flag = 0; Key4_flag = 0; Key3 = 1; 2 / 5 } else; } if(Key4 == 0) { delayms(50); if(Key4 == 0) { Key4_flag = 1; Key1_flag = 0; Key2_flag = 0; Key3_flag =