不锈钢水箱使用说明.pdfVIP

上海辉旗环保科技有限公司 不锈钢水箱安装使用说明 Stainless steel water tank installation instructions 一、本系列水箱为上海辉旗不锈钢 SUS304 材质制品；具有极高的耐腐蚀性，不锈钢 水箱体采用凸面模板拼装焊接，可根据现场的结构，不同的尺寸要求，不同的吨 位要求进行灵活组装， 耗材较少， 结构强度较高， 无需大型吊装设备， 运输方便； This series of shanghai huiqi water tank is a stainless steel SUS304 material products; with high corrosion resistance, stainless steel water tank body adopts convex template assembling and welding, according to the structure, different size, different tonnage requirements for flexible assembly, less consumables, the structural strength is high, there is no need of large lifting equipment, transportation convenient; 二、水箱在使用前核对设计图纸，尺寸、箱体开孔位置与设计图相符； Water before use to check the design drawings, size, the hole position and design; 三、安装前将基础梁垫水平，水箱底部平面必须固定在同一水平面上，不可擅自移动 水箱位置或方向；槽钢支架应用螺丝或水泥固定，放置位置靠近墙体，需另设防 护网，以防支架锈蚀或大风导致意外； The foundation beam pad level before installation, the plane at the bottom of the tank must be fixed at the same level, can not be arbitrarily mobile tank position or direction; the fixed supporter with screws or cement, placed near the wall, the need of additional protective net, to prevent corrosion or wind guide greets outside support; 四、不锈钢方形水箱基础要求：砼基础几何尺寸应按 GB02S101 有关规定制定；砼基 础平面高低差 5mm；砼基础的尺寸应根据水箱的大小保持一致， 相邻两条基础的 中心距离≤ 800mm，单条砼基础的宽度＞ 200mm； Stainless steel square water tank foundation requirements: concrete foundation geometry size should be in accordance with the relevant provisions of the GB02S101 formulation; concrete foundation level difference of 5mm; the concrete foundation should be sized according to the size of the t