一种新型排风热泵热回收型新风机的特性研究.docxVIP

MACROBUTTON MTEditEquationSection2 SEQ MTEqn \r \h SEQ MTSec \r 1 \h SEQ MTChap \r 1 \h 一种新型排风热泵热回收型新风机的特性研究 摘 要 随着人们生活水平的提高，人们对室内空气品质的要求也越来越高。新风若不加以处理便直接送入室内，势必会增加空调系统的能耗。为了降低空调系统能耗，同时节约能源，本文设计了将排风热回收技术应用于空调新风系统中，回收排风中的能量。 首先，本文设计了一种新型热泵热回收型新风机组，该机组结合了回风过冷以及混风冷凝技术提升了新风机组的能效。同时利用GREATLAB仿真模拟平台对该新风机组进行仿真模拟，并进行了部件及系统的参数优化，得到了性能较好的模型机组。 然后，委托某企业制作样机，并在该企业焓差实验室测试样机性能，进一步验证仿真的准确性和机组的能效。实验表明，GREATLAB仿真平台精度高，机组在制冷标准条件下系统能效可达3.65。 最后，本文探讨了如何将新风机组应用于温湿度独立控制空调系统，利用水机与新风机的组合实现温湿度的独立控制，设计了一种新型新风空调一体机，其中水机控制室内显热负荷，新风机控制室内潜热负荷。 关键词：新风机组；热泵热回收；仿真模拟；温湿度独立控制  Abstract With the advancement of science and technology, peoples requirements for indoor air quality are getting higher and higher. If the fresh air is sent directly to the room without treatment, it will inevitably increase the energy consumption of the air conditioning system To reduce the energy consumption of air conditioning system and save energy, this paper presents that the exhaust heat recovery technology can be applied to the DOAS (Dedicated Outdoor Air System) to recover the energy in the exhaust air. Firstly, this paper presents a novel design of exhaust air heat hump, which combines the return air subcooling and the mixed air condensation technology to improve the COP of the exhaust air heat hump. At the same time, the simulation model of the outdoor air handling unit using exhaust heat hump was established by using GREATLAB simulation software. As the parameters of the components are optimized, it can provide space cooling with fresh air exchange and reduce power consumption. Then, a prototype was built in a factory and tested in a company. The experimental results show the accuracy of the simulation model and evaluate the performance of the exhaust air heat pump, which can get a higher COP (3.65 in standard refrigeration condition). Finally, this paper considers how to apply the exhaust air heat hump to the THIC (Temperature and Humidity Independent Control) system, and presents a new design of air co