第三部分：光纤布线施工管理与工期控制-课程.ppt

将基座按图型指示置于底座上 光纤端接 按箭头所指方向小心地、轻轻地拉动基座使光纤能够平稳地经过切割刀 光纤端接 将基座在砂纸上轻轻地来回拉动10-15次 注意一定不要用力 光纤端接 清洗端接面 光纤端接 用放大镜观察端接面 光纤端接 在光纤的另一端透光的情况下，最好的效果是看到通明透亮的同心圆，如中间的图，如果同心圆上有黑点，说明端面不平整或有灰尘，两种情况都可能带来衰减。 光纤端接 从各个角度清洁光纤 使用此三角形 作为基准 光纤端接 将上盖按光纤固定器的绞链孔插入 光纤端接 安装下盖 光纤端接 安装下盖 光纤端接 将尾套安装到位 光纤端接 检查光纤是否在V型槽的中央. 施工中充分利用可见光源 检测连续性 查找贴错的标签 检测不合格的端接面 检测光纤的通断，在进行模块端接之前先行检测一下光纤的通断，以免造成不必要的人工及材料的浪费 施工安排与工期控制 TO端和配线架端一对一同时施工，从而边端接边测试 每个施工人员负责一块指定区域的VF45制作，以便故障查找 在整个施工过程中，固定两名测试人员对每条链路进行及时测试，并将测试结果记录在案 50条光纤链路/天 感谢各位观看 THANK YOU To attach the pull line to the fiber, strip back the jacket, exposing the kevlar and the buffer tube. Knot the kevlar to the pull line and cut the exposed buffer tube. Tape over the knot to produce a smooth pull. Once you have the cable installed, and dressed into the closet, the next step will be to install the fiber patch panels. When installation is done with the 2-U or 3-U patch panel, the lid of the unit can be used as a work station for the terminating tools. When mounting the slide brackets in the rack, screws are inserted into the middle holes. The easiest way to manage and terminate the fibers is to run the proper cable through the port on the patch panel, then create a type of assembly line. Cut and remove all of the jackets, remove the kevlar, put on your boots, then begin to terminate each line seperately and routing them into the patch panel one at a time. Be sure to pull the cables out of the port prior to the termination process, as the connector is locked into place from the rear of the panel, not the front. If you do make the mistake, simply disassemble the connector and carefully pull the socket fiber holder back through the port and reassemble it on the other end. All fiber management in the patch panels is accomplished by managing the buffer tubes only. The jacket is strain relieved at the back of the unit. When terminations are complete, the patch panel is locked in the closed position by adding the screws to the upper and lower mo