ulink2管脚连接说明.docVIP

Target Connectors Home??? Hardware Description?? Target Connectors ULINK2 provides five JTAG connectors. They support various cable types, which are used for debugging different targets. The connectors provided are: A narrow (2.00mm/0.079) pin spacing) 20-pin connector for ARM targets, A standard (2.54mm/0.1) 20-pin connector for ARM targets, A 16-pin connector for Infineon OCDS (JTAG) targets, A 14-pin connector for STMicroelectronics μPSD targets, and a 10-pin connector for ARM targets (Mfgr: Don Connex P/N: C42 or Samtec P/N: SHF-105-01-L-D-TH). The? Samtec part?is available with different options for plating, tail, shroud, and lead style. A cable for each connector is shipped with the ULINK2?Standard Product. If you must change cables, then make sure to line up the marker stripe on the cable with pin 1 of the connector. Pin 1 is labeled on the board. ULINK2 Adapter Connectors (cover off) ULINK2 supports both JTAG and Serial Wire Mode interfaces. Refer to the appropriate pinout diagram for the ULINK2 adapter connectors to make sure they match your target hardware. JTAG Interface Signal Connects to... TMS Test TDO Test Data Out pin. RTCK JTAG Return Test ClocK. (see Note below) TDI Test Data In pin — Use 100K Ohm pull-up resistor to VCC. TRST Test ReSeT/ pin — Use 100K Ohm pull-up resistor to VCC. TRST is optional and not available on some devices. You may leave it unconnected. TCLK Test CLocK pin — Use 100K Ohm pull-down resistor to GND. VCC Positive Supply Voltage — Power supply for JTAG interface drivers. GND Digital ground. RESET RSTIN/ pin — Connect this pin to the (active low) reset input of the target CPU. CPUCLK CPU clock (according IEEE Standard 1149.1). OCDSE Enable/Disable OCDS interface (Infineon-specific). TRAP Trap condition (Infineon-specific). BRKIN Hardware break in (Infineon-specific). BRKOUT Hardware break out (Infineon-specific). /JEN JTAG Enable (STMicroelectronics specific). TSTAT JTAG ISP Status (STMicroelectronics specific) (optional