上海巴斯夫基坑围护工程.pdfVIP

上海巴斯夫基坑围护工程 Index 目 录 ⅠProject Description 工程概况 ⅡConstruction Plan Basis 施工方案的编制依据 Ⅲ Construction Diagram 施工流程 Construction Method 施工方法 ⅤQA Measures 质量保证措施 Ⅵ Safety Civilized Construction 安全及文明施工 Ⅶ Manpower Arrangement 劳动力的配置 Ⅷ Construction Equipment 施工机械的配备 Attachments: Plans, Sections and Protection Calculation Explanation 附：平面图、剖面图及围护计算书 第 1 页第 1 页 上海巴斯夫基坑围护工程 Ⅰ Project Description 工程概况 BASF Shanghai IIP project U/G Pipeline and Foundation Pit Protection Package is located in square A500 A600 Chuhua Rd. and Shengong Rd. of SCIP. According to site investigation, jobsite is relatively leveled. And from geological report, ②3-1 is 2-4m thick sandy silt. Due to absence of No.③ and ④ soil layers, ground condition is comparatively poor, and sheet pile’s self standing condition can not be satisfied (see detail in protection calculation explanation). Therefore, we plan to set up round purlin and brace at -0.8m of sheet pile top. Steel round purlin is spliced with two 30# C-shape channel steel, and 400# H-shape channel steel are used for some deeper places. Braces are made of ￠280*10 steel pipes, and ￠609*12 steel pipes are to be used for some places. 上海巴斯夫联合异氰酸脂项目地下管网及构筑物基坑围护工程。位于上海工业区楚华路/神工 路 A500 、A600 地块。根据现场勘察，场地较为平整。从现有地质报告反映，该地块②3-1 为砂质粉土，层厚 2-4m 。由于该地块缺少③层和④层土层，地质也较差，故钢板桩没有满 足自立式的要求（详见围护计算书），故考虑在钢板桩桩顶标高－0.8m 处设置围檩和支撑。 钢围檩采用 30#C 型槽钢双拼，局部较深的地方采用 400#H 型钢。支撑采用￠280*10 圆管支 撑，局部地方采用￠609*12 园管支撑。 As per protection calculation explanation, when foundation excavation is over 3m, 4#sheet pile with small interlocks will be used (12m long), and when excavation is less than 3m, 30# C-shape channel steel will be used(9m long). 根据围护设计计算，本施工方案确定：在基坑开挖大于 3m 时，采用 4#小咬口拉森桩（桩长： 12m/根）支护。基坑开挖深度小于 3m 时，采用 30#C 型槽钢（桩长：9m/根）支护。 Ⅱ Constru