小松挖掘机PC200LC-7L（英文版）装修手册：s000.pdf

2020 TESTING, ADJUSTING AND TROUBLESHOOTING 2020 STANDARD VALUE TABLES12 20-2 ENGINE PARTS 20-2 CHASSIS PARTS 20-3 FLOW CONTROL CHARACTERISTIC OF PC VALVE 20-12 TESTING AND ADJUSTMENT 20-101 TROUBLESHOOTING 20-201 TROUBLESHOOTING 20-301 ELECTRICAL SYSTEM SERVICE CODE AND MECHANICAL SYSTEM FAILURE CODE 20-302 TROUBLESHOOTING 20-501 ELECTRICAL SYSTEM - E MODE 20-502 TROUBLESHOOTING 20-601 MECHANICAL SYSTEM - H MODE 20-602 The following precautions are necessary when using the standard value tables for testing and adjusting or for trouble- shooting. 1. The values in the tables are for new machines and are obtained from reference to values when the machine is shipped from the factory. These values should be used only as a target guide for judging the progress of wear or when repairing the ma- chine. 2. The standard values for judging failures are based on the results of various tests when shipping the machine from the fac- tory. These values should be used as reference together with the repair condition and operating record of the machine to make judgement on failures. 3. These standard values do not form a basis for judging claims. WARNING! When carrying out testing, adjusting or troubleshooting, position the machine on level ground and use blocks to prevent the machine from moving. WARNING! When carrying out work together with other workers, use agreed signals and do not allow unau- thorized people near the machine. WARNING! Wait for the engine coolant to cool before checking the coolant level. If the radiator cap is removed while the coolant is still hot, the coolant will spurt out and cause burns. Be careful to stay away from the fan, fan belt and other moving parts PC200LC-7 PC220LC-7