华侨大学传感器实验 4.docxVIP

华侨大学传感器实验 4 华侨大学传感器实验lpar;4rpar; 姓名学号时间7.8光照传感器采集实验 #includeioCC2530.h #defineuint8unsigned char #defineuint16unsigned int #defineuint32unsigned long extern void Sensor_PIN_INT(void); extern uint16ReadAdcValue(uint8ChannelNum,uint8DecimationRate,uint8RefVoltage); charuart_buffer; void delay(void) unsignedinti; unsigned char j; for(i=0;i for(j=0;j asm(NOP); asm(NOP); asm(NOP); void UartTX_Send_String(unsignedchar *Data,intlen) for(j=0;j U0DBUF =*Data++; while(UTX0IF==0); UTX0IF =0; }//串口发送函数 void UartTX_Send_Data(unsignedchar Data,intlen) for(j=0;j U0DBUF =Data; while(UTX0IF==0); UTX0IF =0; #pragmavector=URX0_VECTOR __interruptvoid uart0(void){//uart0中断函数//串口发送函数 URX0IF =0; //清中断标志 P0_0=~P0_0; uart_buffer=U0DBUF; //UartTX_Send_String(welcome,10); UartTX_Send_Data(uart_buffer,1); void main(void ) unsigned char buf[8]; uint16temp; P0DIR |=0x01; //设置P0.0为输出方式；P0.4和P0.5为输入方式 APCFG =(0x1 P2DIR |=0x01; P0_0=1; //设置P2.0为输出方式 P2_0=1; //熄灭LED CLKCONCMD =~0x40;//选择32M 晶振 while(!(SLEEPSTA0x40)); //等待XSOC 稳定 CLKCONCMD =0xb8; //TICHSPD128分频，CLKSPD 不分频 SLEEPCMD |=0x04; //关闭不用的RC 振荡器 PERCFG =0x00; //位置1P0口 P0SEL =0x3c; //P0用作串口 U0CSR |=0x80; //UART方式 U0GCR |=10; //baud_e=10; U0BAUD |=216; UTX0IF =1; U0CSR |=0X40; IEN0|=0x84; Sensor_PIN_INT();//波特率设为57600//允许接收//开总中断，接收中断 UartTX_Send_String(Testing...\r\n,12); while(1){ P2_0=~P2_0; temp =ReadAdcValue(4,3,0x2);//P0.4采集光照度，12bit,AVDD5作为参考 temp =(temp4); buf[0]=(uint8)(temp0xff); buf[1]=(buf[0]4)0xf; buf[2]=buf[0]0xf; if(buf[1]0x9) buf[1]=buf[1]-0XA +A; buf[1]=buf[1]+0; if(buf[2]0x9) buf[2]=buf[2]-0XA +A; buf[2]=buf[2]+0; UartTX_Send_String(LIGHT=,8); UartTX_Send_String(buf[1],1); UartTX_Send_String(buf[2],1); UartTX_Send_String(\r\n,2); delay(