CISCO光存储交换机MDS9100密码破解.pdfVIP

Password Recovery Procedure for the MDS 9000 Series Multilayer Directors and Fabric Switches Document ID: 29441 Contents Introduction Prerequisites Requirements Conventions Step-by-Step Procedure Related Information Introduction This document describes the procedure to recover a lost administrator password from the console port of a Cisco MDS 9000 Series Switch. Prerequisites Requirements You must perform the password recovery procedure on the Supervisor Engine module that will become the active Supervisor Engine module after completion of the recovery procedure. In order to ensure that the other Supervisor Engine module does not become the active module, perform one of these two options: ? Physically remove the other Supervisor Engine module from the chassis. ? Change the console prompt of the other Supervisor Engine module to one of these two prompts until you complete the procedure: ? loader ? switch (boot)# Note: Refer to the Cisco MDS 9000 Family of Multilayer Directors and Fabric Switches configuration guide for more information about these prompts. Conventions Refer to Cisco Technical Tips Conventions for more information on document conventions. Step-by-Step Procedure Perform these steps in order to recover a lost administrator password from the console port of a MDS 9000 switch: 1. Perform these steps in order to establish a console session to the MDS 9000 switch: a. Connect one of the supplied RJ-45-to-DB-9 adapters to the PC serial (COM) port. b. Connect the other end of the supplied RJ-45-to-DB-9 adapter to the RS-232 management port on the MDS 9000 switch. 2. Reboot the switch in one of these ways: ? Issue the reload command if there is a Telnet session with administrator rights. switch# reload The supervisor is going down