OTISSKY1电梯故障代码大全及主板指示灯及开关说明要点.docxVIP

OTIS SKY 电梯故障代码 闪烁的信息 可能的原因 TCI - Lock 轿顶检修开关操作顺序不准确，必须按以下顺序操作 1.打开厅门.2.轿顶检修开关由检修打到正常状况.3.关闭 厅门 如果不按照上面的顺序操作，电梯将不能正常运行，同时 LCBII板上的INS指示灯将会闪烁。 LS - Fault a）上强迫减速2LS和下强迫减速1LS信号不正常 start DCS! a）在没有完成门检查启动（DCS）操作之前正常运行不允许. b）正常操作时，当电梯停在门区且轿厢门完全打开（DOL有 效）时，厅门门全闭信号被触发（DW有效）.此时小心检查井道 厅门门锁是否被短路. 按 M - 1 - 3 - 5 启动 DCS ! 1LS + 2LSon 限位开关1LS和2LS同时动作. DBP-Fault 电梯运行必须按正确的顺序完成. 当电梯减速停二车时门区信号没有被检测 ，这个原因可能是 LVC继电器故障. 这个错误事件被存储在 LCBII EEPROM上,只能使用检修 INS开关来进行电梯操作. DBSS-Fault 变频器没有准备. Adr.- Check 特殊远程站地址没有对应于标准IO列表 TCI ( 691 ) = 16 - 3, 1LS ( 692 ) = 16 - 1, 2LS ( 693 ) = 16 - 2, SE - Fault 电梯因丢失 SE信号不能启动（检查SKL, THB, door bypass,保险丝， ） 闪烁的信息英文说明 Blinking Event Messages The fol towing messages are blinking in each status display of the Service Tool: Blink. Message Description related setup wrongBoard The software cannot identify the board, replace the TCBC. wrong E2P The EEPROM has not the correct size MRO active The SPB requests to ignore the inputs at Manual Rescue Run. Learn Run The drive package is performing its Learn Run to leam the Koistway situation The drive package is adjusting the encoder - wait until the leam run has completed DRV-TYP=0 DoorBridge DW or DFC input has not been low while the door was opened. Reason is a bridged door lock 4 check safety chain - This event is stored into EEPROM so that the ONLY way to bring me elevator into operation again is by using INS. Switch INS iviesdtje Landing door was opened for longer than 4 seconds or the car door is bndged. Elevator is taken out of service. This event is stored into EEPROM so that the ONLY way to bring the elevator into operation again is bv usma INS. TCI-lock The sequence to leave TCI-moje was not correctly followed: open door switch TCI off close door TUM / TDM One of the trigger models (up or down) RSL inputs detected a failure (needed for reduced hoisiway). - check event log / switch to ERO to reset (after solving). HWV-TYP. ios 1047 - 1051 1LS*2LS on Limit switches 1LS and 2LS are active at the same time. - C