screen3英文完整版使用说明.pdf

EPA-454/B-95-004 SCREEN3 Model Users Guide U.S. ENVIRONMENTAL PROTECTION AGENCY Office of Air Quality Planning and Standards Emissions, Monitoring, and Analysis Division Research Triangle Park, North Carolina 27711 September 1995 DISCLAIMER The information in this document has been reviewed in its entirety by the U.S. Environmental Protection Agency (EPA), and approved for publication as an EPA document. Any mention of trade names, products, or services does not convey, and should not be interpreted as conveying official EPA approval, endorsement, or recommendation. ii PREFACE The SCREEN3 Model Users Guide is an update to Appendix A of Screening Procedures for Estimating the Air Quality Impact of Stationary Sources (EPA, 1988), which was later revised and published as a separate document (EPA, 1995a). The SCREEN3 model includes several modifications and enhancements to the original SCREEN model, including updates to the code to ensure consistency with the dispersion algorithms in the Industrial Source Complex (ISC3) model (EPA, 1995b). Also, three new non-regulatory options were added to the code. Although attempts are made to thoroughly check computer programs with a wide variety of input data, errors are occasionally found. Any suspected errors and technical questions regarding the use of the SCREEN3 model should be directed to Chief, Air Quality Modeling Group, OAQPS/EMAD, MD-14, Research Triangle Park, NC 27711. Copies of the SCREEN3 model may be obtained from the National Technical Information Service (NTIS), U.S. Department of Commerce, 5285 Port Royal Road, Springfield, VA 22161, telephone (703) 487-4650, or may be downloaded from the Support Center for Regulatory Air Models (SCRAM)