内置双轴心导轨.pdfVIP

深圳市恩科尔科技有限公司 双轴心直线导轨的优点 Superiority of dual-shaft linear rail 价格优势Superiority of price 降低二分之一的产品价格 减少三分之一的产品组装时间 降低四分之一的维修及替换费用. Price of products being reduced by one half Time for installation being reduced by one third cost for repair and replacement being reduced by one fourth 高精度 High precision 重复精度：误差在三微米以内 速度：比现有的其它型号快五倍，速度每秒可达 10 米长及低噪音 直线度：正负十微米以内 可调式导轮预压：在不同负载下，通过调节预压使导轮和导轨之间的间隙达到 “零” 平行式轴承导轮：在 0-6 米内提高了平行精度而不产生明显误差 Repetition error : within three microns Speed : it is five times that than other existing products up to ten meters per second and lower noise linearity : deviation within ± ten miorons Adjustable roller pressure :adjusting the pressrure accordig to different load conditions to achieve “zero” gap Adjustbale roller support improves linearity of movement without causing any noticeble error in 6 meters 高可靠性High reliability 偏心螺母设计：调节简易，应不同的负载调校到最适合的间隙， The eccentrical roller-bearing support may be adjusted very simply and reliebly to “zero” gap under various loading conditions 防松设计：偏心螺母式,轴承导轮的固定螺母设计有防松功能 Prevention of uncontrollbale wobbling: eccentrical roller support 高防磨性 High resistance to grinding 钢轴经过特别加硬处理，抗磨性极高 The surface of steel shaft is hardened to greatly improve resistance to wear due to grinding 设计独到 Special design feature 产品设计坚固 （铝材和高碳钢结合），可作支架或底板使用，大大减低设计及制作成本而达到最高效益 All products are so strongly built to serve not only the normal operation but also act,very cost-effectively, as trestle and chassis 价格大众化 Low price 以低于滚珠导轨的价格而得到同等的精度及质量 The same quality of products but at lower price 专业化生产多种材质的直线轴