10KV变电站的电气一次设计.docx

10KV变电站的电气一次设计 摘要：本设计设计了一个电子厂的供电系统，在满足工厂供电设计中安全、可靠、优 质、经济的基本要求的前提下，本文首先根据全厂和车间的用电设备情况和生产工艺 要求，进行了负荷计算，通过功率因数的计算，进行无功补偿设计（包括无功补偿容 量计算和补偿设备选择、校验），确定了电子厂的供电方案，通过技术经济比较，确 定了供电系统的主接线形式，选择了主变压器的台数和容量。其次，本文设计了厂区 供电和配电网络，进行了车间变电所以及车间配电系统和车间电气设计，按照经济电 流密度法，选择了合适的导线和电缆，通过合理设置短路点，进行正确的短路电流计 算，进行了主要电气设备的选型和校验。 关键词：供电系统；负荷计算；主变压器；设备选择 Abstract : The design of an electronic factory power supply system, power plant design to meet safety, reliability, quality, basic requirements of the economy under the premise of this paper, according to all electrical equipment factory and workshop conditions and production process requirements, for a load calculation, by calculating the power factor, reactive compensation in the design (ineluding reactive power compensation capacity calculation and compensation equipment selection, calibration), to determine the supply of electronic works program, through technical and economic comparison of the power supply system to determine The main connection fonn, select a main transformer station number and capacity? Secondly, the paper design of the power plant and distribution network, conducted a workshop and the workshop substation electrical distribution systems and plant design, in accordanee; with the economic current density method, select the appropriate wire and cable, through a reasonable set short-circuit point, for correct short-circuit current calculation, carried out a major electrical equipment selection and validation.? Key words： power system, load calculation, transformer , equipment selection TOC \o 1-5 \h \z \o Current Document 第0章、绪论 1 \o Current Document 第1章、分析原始资料，确定电源的引入方式 3 \o Current Document .工厂总平面图 3 \o Current Document .工厂生产任务规模及产品规格 3 \o Current Document 工厂负荷情况 3 \o Current Document 供电电源请况 4 \o Current Document .气象资料 4 \o Current Document 第2章、负荷计算及无功功率补偿计算 5 \o Current Document 用电设备负荷的计算 5 \o Current Document 负荷计算表 6 \o Current Document 无功功率补偿 7 第3章、变电站的位置与型式、合理地布置好各设备的位置 10 \o Current Document .主变压器