UL94V0,V1,V2是不同的阻燃等级.pdfVIP

如何理解 UL94HB , UL94-V0 , UL94-V1 , UL94-V2 UL94V0,V1,V2 是不同的阻燃等级 ,其等级不同 ,耐燃的测试方法亦不同 ,测试判定 的标准也不同 .V0 的测试方法是将测试物倾斜 45 度 ,用酒精灯点燃 ,移开火源 后 ,10 秒内熄灭 .V1,V2 的测试方法同 V0 一样 ,不同的是移开源后 ,熄灭的时间比 V0 要长 ,也就是 V0 的阻燃性最好 ,V1 第二 ,V3 第三 ,V4 的和不是阻燃的一样 . 你提的 V-0 是 UL94 标准里的一种等级，根据 UL94 ，大体可以分为： HB 、V-2 、 V-1 、V-0 、5V ，耐燃等级依次提高， HB 是最低级别的，基本上不阻燃，一般电 器产品使用 V-2 以上就基本上达到要求。 楼上说得对，一般有 5VA ，5VB 等级，这就很高的了。我们做到美国市场的塑 胶件，与电子板接触的要用到 5VA 材料，但是很难做到，我们就在 V ）基础上 加厚塑胶来达到 5VA 的要求。 IEC 60695 –2-10, the glow wire FR test, simulates the effect of thermal stresses which may be produced by heat sources like glowing elements or overloaded resistors, in order to asses the fire hazard by a simulation technique. The glow wire test involves intimate contact between a hot wire and the surface of the part to be tested at the point where the moulded part is most vulnerable. The temperature of the wire is maintained at 960, 850, 750, 650 or 550 C. For HIPS usually 960, 850 and sometimes 750 C are used, for PP mainly 960 or 850 C. A contact time of 30 s between the hot wire and the part surface is maintained and, in order to pass, the test part should not maintain a flame for more than 30 s after retraction of the wire and should not generate burning drips. The official standard requires testing to be done on the moulded part but, for the purpose of this study, test plaques with varying thickness were used. UL94 V0/V2 The UL94 standard evaluates the actual response to heat and flame of materials under controlled laboratory conditions. The UL94 test is performed with a 20 mm vertical flame by twice contacting a moulded sample with dimensions of 12712.7thickness in mm for 10 s. In order to pass UL94 V2, the flame should extinguish within 30 s after each ignition and with a maximum burn time of 250 s for 5 samples. Burning