杉木板条横向线拼工艺初探_李宁.pdfVIP

TECHNOLOGY 科技 技术探讨 杉木板条横向线拼工艺初探 1 2 1 1 2 1 李 宁，汪长球，张 崴，袁全平，黄宝勤，程芳超 1. 广西大学资源环境与材料学院，南宁 530004；2. 广西天峨县细木工板厂 ，广西 河池 547300 摘要： 探索通过浸胶线绳连接的方式横拼杉木板条取代传统胶拼。采用单线拉伸的方式测定浸胶线绳连接的胶接性能，研究浸 胶线绳连接中线绳种类、胶种、开槽宽度等因素对浸胶线绳胶接破坏载荷的影响，分析优化浸胶线绳连接方式。结果表明，市 售棉线及尼龙线作为连接线绳的破坏载荷较高，同时开槽宽度为1.5 mm时的破坏载荷优于开槽宽度为1.0 mm的破坏载荷；通过 对浸胶线绳连接工艺参数的进一步优化，并结合工业化生产要求，可得最优的条件为：胶种为热熔胶，线绳为棉线，开槽深度为 2.0 mm。利用该工艺制备的细木工板的横向静曲强度和表面胶合强度达到了国家标准GB/T 5849—2016《细木工板》的要求。 关键词： 杉木；拼板；浸胶线绳连接 中图分类号： 文献标志码： 文章编号： TS653 B 1673-5064（2021）02-0008-06 Study on the Optimization of the Splicing Process of Chinese Fir Wood with the Gluing Thread 1 2 1 2 1 Li Ning , Wang Changqiu , Yuan Quanping , Huang Baoqin , Cheng Fangchao 1. School of Resources, Environment and Materials, Guangxi University, Nanning 530004, China 2. Guangxi Tian’e Blockboard Factory, Hechi, Guangxi 547300, China Abstract: The production process of wood panels with Chinese fir wood, such as glued laminated lumber and blockboard, usually involve the panel splicing process, and the transverse splicing was mostly carried out by gluing. In order to reduce the use of adhesive and realize the transverse splicing of thin plates, the way of gluing tread connection was explored to replace the traditional gluing process. The bonding strength of gluing tread connection was measured by the way of single line stretching, and the influences of the thread type, the adhesive type and the slot width on the bonding strength of the gluing tread connection were studied. The results showed that the bonding strength of the sample using the commercial cotton thread and