机电工程施工技术方案.pdf

MEP Work Construction Code 机电工程施工技术方案 Water piping 水系统安装工程部分 1. Standard and Requirement of the Pipe Engineering Part 管道工程部分规范及要求 1.1. Feed water Part：给水部分： 1.1.1 “-4” means wired port, the general length of connection wired teeth is 1.3cm-3cm. and the wred port connected should be outer 3~4 teeth, and it can be connected with normal wired for “4”and upper. “-4”为丝口连接，一般连接丝牙长度为1.3cm-3cm，而且丝口连接后丝牙应外露3~4 牙， 4” 以上可以用法丝连接。 1.1.2 The conjunction materials are unsintered tape, ramie silk, thick white paint, and anti- oxygen sealants 。 连口材料为生料带、麻丝、厚白漆、厌氧性密封剂。 1.1.3 The galvanization pipeline must use the galvanization fittings; the damaged galvanization part must be embalmed. 镀锌管道还必须得用镀锌配件，损坏镀锌层部分的要加以防腐处理。 1.1.4 The pipe keeps the distance of 1.5cm~2cm away from the wall, and the every level of pipe clip should be between 1.4cm and 1.6cm, the pipe clip is placed at the distance of 15cm away from every cross, and the stents should be used if the pipes are more than 25. 管边离墙1.5cm~2cm，管卡每层应在1.4cm~1.6cm 之间，每转弯出15cm 左右设管卡， 大于25 管要用支架。 1.1.5 The verticality of the edge of potable water pipe should be minor than 2mm. 上水管边每层垂直度不得大于2mm. 1.1.6 The pipe clip is placed at the distance of 10~15cm away from every cross ofsubpipe, U clip should be used if the pipes are more than 40: 支管每转弯处10~15cm 设管卡，大于40 以用U 型卡固定： 1.1.7 15 20 25 32 40 50 T 2.5m 3m 4.5m 4m 4.5m 5m h e flex tie should be used when the water pipe cross the settlement joint. 水管过沉降缝时要用伸缩接头。 1.1.8 The shockproof joints should be used when the pipes are near the water mercury or mechanical peripherals. 水管在靠近水汞或机械周围的全部用防震接头 1.1.9 When the cold water pipes are parallel with the hot water pipes, the hot water pipes should be abov