Hpermesh-加速度计施加实用.pdfVIP

How to create an Accelerometer in Hypermesh for use in LS-DYNA Option 1 ? Create an elasticmaterial collector (type 1) and use the following properties o Rho = 7.89E-09 o E = 210000 o NU = 0.3 ? Create aproperties collector using SecSld as card image ? Create acomponent collector and call it accelerometer ? Create a 25 mm x 25 mm x 25mm cube in the new component you just created. ? Link component, material and properties ? Translate the accelerometer you just created to the location specified in your test report (tools, translate) ? Create a *CONSTRAINED_NODAL_RIGID_BODY o Select 1D menu o Select rigids o Select multiple nodes (as in figure below) o Select all 8 nodes of cube, and the 4 nodes to connect to your part (make sure you select all 8 nodes of the cube) o Select create (figure below) 1 ? Select card o Select element (click on the NRB you just created) o Select edit o Set the IPRT option to 1 (figure below) ? Go to the BCs menu ? Select control cards o Select Next (next page) o Select CONTROL_OUTPUT Turn on the optional card Set IPRTF to 2 (MAKE SURE IT IS SET = 2) Select return o Select DATABASE_OPTION Set RBDOUT to be 2E-04 Select return 2 How to create an Accelerometer in Hypermesh for use in LS-DYNA Option 2 ? Create a rigid material collector (type 20) and use the following properties