压力表检测仪器仪表.docxVIP

— PAGE \* Arabic 1 — 压力表检测仪器仪表 Dead weight testers are used for examination and calibration of pressure gauges and other pressure measuring instruments without using an external instrument. The main components are the measuring system, the valve units, the built-in screw pump for accurate pressure adjustment and the set of weights.  The measuring system itself consists of a precise lapped-in pair of piston and cylinder. During the measuring process the piston is forced up by the pressure produced with the built-in screw pump re-spectively with external pressure supply, while the regular weights and maybe further extra weights, if required for the designated test pressure, press it down.  With the built-in screw pump the test pressure can be adjusted to an equilibrium of the forces. When the forces on both sides of the piston are in balance, the piston will be floating, and the designated test pressure is reached exactly.  For simplifying the handling, the instrument-specific weights are already referred to each relevant determined piston area and stamped with the pressure unit (bar/kPa).  The influence of the friction between piston and cylinder is mini-mised by keeping piston and weights rotating while floating.The models described in this data sheet are available for pressure ranges 0.1 to 6, 0.1 to 10 resp. 0.1 to 25 bar.  Technical data  ? Pressure range: PD 6 0.1 to 6 bar  PD 10 0.1 to 10 bar  PD 25 0.1 to 25 bar  ? Set of weights in bar / kPa  ? External pressurised air supply for PD 10 and PD 25 required, indeed as high as the pressures that have to be examined 1); external pressurised air supply for PD 6 recommended (compare page 2) ? Accuracy of the adjusted examination pressure: better 0.05 % resp. 0.03 % (with official verification or DKD-approval) referred to the effective pressure. Up to 0.6 bar the maximum error is  constantly ±0.3 mbar (at 0.05%) resp. ± 0.18 mbar (at 0.03%)  ? Reference condition