扫描枪设置-Honeywell-4600归类.pdfVIP

4600g, 4600r, 4600rp, 4800i Quick Start Guide Note: Refer to your user ’s guide for information about cleaning your device. For localized language versions of this document, go to /aidc. Getting Started Turn off computer ’s power before connecting the scanner, then power up the computer once the scanner is fully connected. USB Connection 1 Keyboard Wedge Connection Serial (RS-232) Connection 2 Reading Techniques The view finder projects an aiming beam that should be centered over the barcode, but can be positioned in any direction for a good read. Hold the scanner over the barcode, pull the trigger, and center the aiming beam on the barcode. The aiming beam is smaller when the scanner is closer to the code and larger when it is farther from the code. Hold the scanner close to smaller barcodes, and farther away from large barcodes to get a proper read. If the barcode is highly reflective (e.g., laminated), you may need to tilt the scanner at an angle so the barcode can be scanned. Standard Product Defaults The following barcode resets all standard product default settings. Standard Product Defaults 3 Interface Scan the barcode that describes the PC or interface you are using. USB Keyboard (PC) RS-232 Japan DOS/V USB Japanese Keyboard (PC) AT/PS2 Keyboard Wedge (Default) Emulate External Keyboard 4 Keyboard Country Scan the Program Keyboard Country barcode below, then scan the numeric barcode(s) from page 10 , then the Save barcode to program the keyboard for your country.