RS Components 电工电料 线壳和插头 1-104257-2 使用说明.pdfVIP

Application Specification AMPMODU* MTE 114--25026 Interconnection System 15 FEB 10 Rev D NOTE All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2 _. i Figures and illustrations are for identification only and are not drawn to scale. 1. INTRODUCTION This specification covers the requirements for application of AMPMODU MTE Interconnection System. This system includes single row wire--to--board and wire--to--wire connectors using 0.64 mm [.025 in.] sq. post technology on 2.54 mm [.100 in.] centerlines. The plastic connector housings are available preloaded with insulation displacement contacts. You may also load your own empty housings using crimp snap--in--contacts. The housings are available in 2 through 25 positions. Accessories for coupling, stacking, latching, polarizing, and special mounting of the connectors are also available. When corresponding with Tyco Electronics Representatives, use the terminology provided in this specification to facilitate your inquiry for information. Basic terms and features of the connectors and contacts are provided in Figure 1. Insulation Displacement Contacts Crimp Snap-In Contacts (Loose Piece or Strip Form) Insulation Barrel/