RS Components 电工电料 焊接套管 D-142-56 使用说明.pdfVIP

SPECIFICATION CONTROL DRAWING MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, radiation cross-linked modified polyvinylidene fluoride. Color: natural. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Cd18 per ANSI J-STD-006. FLUX: TYPE ROL1 per ANSI J-STD-004. 3. MELTABLE RING: Thermally stabilized thermoplastic. Color: blue. 4. MELTABLE RING: Thermally stabilized thermoplastic. Color: gray. APPLICATION 1. This part is designed to provide an environment protected shield termination on cables, rated for at least 105°C minimum, and having tin or silver plated shields. 2. Part may be used on cables having a maximum diameter of 6.48 (0.255) and a minimum diameter of 3.18 (0.125) when measured as shown below. 3. This part is designed to meet the requirements of Raychem Specification RT-1404. 4. Install using Raychem-approved convection or infrared heating tools in accordance with Raychem Process Standard RCPS-100-70. For best results, prepare the cable as shown: Wire and TITLE: Harnessing 6.48 (0.255) I.D. 307 Constitution Drive Menlo Park, CA 94025, USA Products SOLDERSLEEVE, LOW TEMPERATURE Unless otherwise specified dimensions are in millimeters. DOCUMENT NO.: D-142-56 Inches dimensions are in between brackets. TOLERANCES: ANGLES: N/A Tyco Electronics reserves the right to amend DCR NUMBER: REPLACES: 0.00 N/A this drawing at any time. Users should D010115 N/A 0.0 N/A ROUGHNESS IN evaluate the suitability of the product for their 0 N/A MICRON application. DRAWN BY: DATE: