- 1、本文档共8页,可阅读全部内容。
- 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
- 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
Lecture 6 Mesh Preparation Before Output to Solver
Introduction to ANSYS
ICEM CFD
Mesh Preparation Before Output to Solver
Many tools in the Edit Mesh tab
Smooth, check errors, coarsen, refine, individual element editing
Two important things should always be done before outputting the mesh to the solver
Make sure the mesh is error-free by going through the Error and Possible Problem checks
Fix any problems
Smooth the mesh to an acceptable quality
Fix any problems which cannot smooth to the minimum quality
These two steps are not necessary with a structured hexa mesh because they are usually handled with the tools in the Blocking tab
When fixing errors or low quality problems, there are always two basic choices:
If there are few problems, edit the elements directly to fix
If there are many problems, inspect the source of the problem, such as a mesh size or geometry problem, then fix this and remesh
Either choice involves the use of mesh subsets to visualize the problem elements
Mesh Checks
To diagnose mesh connectivity problems
Errors – most likely to cause problems in:
Translation to solver
Solver mesh input
Solution convergence/run
Possible Problems – “Unclean surface mesh”
Strange configurations of elements, sharp peaks
Unwanted holes/gaps
May result in incorrect solution
Definitions of errors and possible problems found in appendix and help
Can check any combination of errors/possible problems
Individually select
Clicking on Error or Possible Problems headings will select all options in column – selecting again will de-select all
Set Defaults will select the most common checks for the current mesh type (2D or 3D)
Check Mode
Create Subsets – creates a subset of elements for each problem found (will run through all selected checks)
Check/Fix Each – offers automatic fixing of some problems (needs user decision after each problem found)
Mesh Checks – Check Mode
If Create Subsets was selected
Will go through all checked criteria without interruption
Elements that
文档评论(0)