AGMA 2000--A88-中文翻译版本.pdf

AGMA 2000--A88 March 1988 1988年3月 (Errata 1992) （勘误表1992年） (PartialRevision ofAGMA 390.03) （对AGMA 390.03进行部分修正） - CAUTION- - 注意- While this document is the current published AGMA Standard on this subj ect, it has been more than 5 years since it was revised or reaffirmed. This Standard is intended for use by the experienced gear designer/engineer who has specific current knowledge of recent technology and is capable of exercising appropriate judgment in its application. It is not intended for use by the “engineering public at large.” 虽然本文件是最新公布的AGMA 相关标准，但实际上本标准经过了5年多的修正和确认。本标准的 期望使用者为：掌握当前技术相关当前知识、能够在应用中进行适当判断的、经验丰富的齿轮设计 师/工程师；而不是“广大工程人员” 。 AMERICANNATIONAL STANDARD 美国国家标准 GEAR CLASSIFICATIONANDINSPECTION HANDBOOK 齿轮分级和检验手册 TolerancesAndMeasuringMethodsForUnassembled SpurAndHelical Gears(IncludingMetricEquivalents) 未组装直齿圆柱齿轮和螺旋齿轮专用公差和测量方法 （包括公制换算） AGMA STANDARD AGMA 标准 AGMA i 2000-A88 GEAR CLASSIFICATIONANDINSPECTION HANDBOOK 齿轮分级和检验手册 Tolerances And Measuring Methods For Unassembled Spur And Helical Gears (Including Metric Equivalents) 未组装直齿圆柱齿轮和螺旋齿轮专用公差和测量方法 （包括公制换算） AGMA 2000-A88 (Partial Revision of AGMA 390.03) （对AGMA 390.03进行部分修正） [Tables or other self-supporting sections may be quoted or extracted in their entirety. Credit line should read