RS Components 其他网络设备 电机驱动芯片 FND43060T2 使用说明.pdfVIP

FND43060T2 Motion SPM 45 Series General Description FND43060T2 is an advanced Motion SPM® 45 module providing a fully−featured, high−performance inverter output stage for AC Induction, BLDC, and PMSM motors. These modules integrate optimized gate drive of the built−in IGBTs to minimize EMI and losses, while also providing multiple on−module protection features including under−voltage lockouts, over−current shutdown, thermal monitoring, and fault reporting. The built−in, high−speed HVIC requires only a single supply voltage and translates the incoming logic−level gate inputs to the high−voltage, high−current drive signals required to properly drive the module’s robust short−circuit−rated IGBTs. Separate negative IGBT terminals are available for each phase to support the widest variety of control algorithms. Features • UL Certified No. E209204 (UL1557) • 600 V − 30 A 3−Phase IGBT Inverter with Integral Gate Drivers and Protection • Low Thermal Resistance Using Ceramic Substrate • Low−Loss, Short−Circuit Rated IGBTs • Built−In Bootstrap Diodes and Dedicated Vs Pins Simplify PCB Layout • Built−In NTC Thermistor for Temperature Monitoring • Separate Open−Emitter Pins from Low−Side IGBTs for Three−Phase Current Sensing SPMAA−C26 CASE MODFC • Single−Grounded Power Supply • Isolation Rating: 4000 Vrms/min. Figure 1. Package Overview • Remove Dummy Pin (Click to Activate 3D Content) Applications