RS Components 其他网络设备 电机驱动芯片 L6474H 使用说明.pdfVIP

L6474 easySPIN – fully integrated microstepping motor driver Datasheet − production data Features ■ Operating voltage: 8 - 45 V ■ 7.0 A output peak current (3.0 A r.m.s.) ■ Low R Power MOSFETs DS(on) ■ Programmable power MOS slew-rate ■ Up to 1/16 microstepping POWERSO36 HTSSOP28 ■ Current control with adaptive decay ■ Non-dissipative current sensing an adaptive decay mode which outperforms ■ SPI interface traditional implementations. ■ Low quiescent and standby currents All data registers, including those used to set ■ Programmable non-dissipative overcurrent analogue values (i.e. current control value, protection on all power MOS current protection trip point, dead time, etc.) are ■ Two-level overtemperature protection sent through a standard 5 Mbit/s SPI. A very rich set of protections (thermal, low bus Applications voltage, overcurrent) makes the L6474 “bullet proof” as required by the most demanding motor ■ Bipolar stepper motor control applications. Description The L6474, realized in analog mixed signal technology, integrates a dual low RDS(on) DMOS full-bridge with all power switches equipped with an accurate on-chip current sensing circuitry suitable for non-dissipative current control and overcurrent protections. Than