Pentair water Aboveground Systems Mounting Base Installation Instructions说明书用户手册.PDF

Aboveground Systems Mounting Base Installation Instructions Kit Contents • AG systems mounting base ( “the system base”) — (Qty 1) • 10-24 threaded brass insert — (Qty 2) • Screw, 10-24 x 2 inch — (Qty 2) • Washer, 10 x 7/16 — (Qty 2) • 1/4-20 threaded brass insert — (Qty 2) • Screw, 1/4-20 x 1-1/2 inch — (Qty 2) • Washer, 1/4 x 5/8— (Qty 2) • Christmas tree pin — (Qty 2) Note: The 10-24 hardware is smaller than 1/4-20 hardware. WARNING — Always disconnect power to the pool pump at the circuit breaker before servicing the pump. Failure to do so could result in death or serious injury to serviceman, pool users or others due to electric shock. Read all servicing instructions before working on the pump. WARNING — DO NOT open the strainer pot if pump fails to prime or if pump has been operating without water in the strainer pot. Pumps operated in these circumstances may experience a build up of vapor pressure and may contain scalding hot water. Opening the pump may cause serious personal injury. In order to avoid the possibility of personal injury, make sure the suction and discharge valves are open and strainer pot temperature is cool to touch, then open with extreme caution. Technical support Sanford, North Carolina (8 A.M. to 5 P.M. - ET) Moorpark, California (8 A.M. to 5 P.M. - PT) Phone: (800) 831-7133 Fax: (800) 284-4151 Web sites: - 710042( Rev A) 2/1/2008 1 Introduction The aboveground system mounting base installation kit contains everything you need to configure and position select Pentai