Agilent Installing the PerkinElmer FID Adapter for the Agilent Dual Plasma Burner Accessory G6600-60622说明书用户手册.PDF

Installing the PerkinElmer FID Adapter for the Dual Plasma Burner Accessory G6600-60622 Purpose To install the FID adapter for use with the Dual Plasma Burner. Scope This procedure describes how to install FID adapters for use with the Agilent Dual Plasma Burner and PerkinElmer 9000XL or Clarus 500 gas chromatograph (GC) instruments. The FID adapter attaches to the base of the Dual Plasma Burner with a 1/4 Swagelok nut and ferrule connection; the adapter itself is specific to the GC with which it is used. Safety Make sure all devices are powered off while performing the installation. Materials • FID adapter kit • The Dual Plasma Burner Procedure 1. Make sure all devices are powered off (Controller, FID, pump, and GC). 2. Attach the FID adapter to the Dual Plasma Burner as indicated in the figures. 3. Set up the FID with normal flow rates (about 30 mL/min H2; 350-400 mL/min). 4. Attach the burner with the FID adapter onto the GC’s FID. Note The FID adapter slides over the ignitor of the PerkinElmer FID and is held in place with two set screws. 5. FID Flame Ignition: Igniting the FID may be more difficult than usual because the restrictor is located near the ignitor. It may be necessary to momentarily increase