Eurotherm欧陆 PC3000 DeviceNet现场总线安装指南.pdfVIP

0 0 0 3 C P DEVICENET SLAVE FIELDBUS CARD MODULE ENG Installation guide The information in this guide is an extract taken from the PC3000 Installation Handbook part no. HA022231 PC3000/VERSION3/ meets the requirements of the European Directives on Safety and EMC. It is the responsibility of the installer to ensure the safety and EMC compliance of any particular installation. The following information is given in addition to the information in the installation and operating instructions to help with this general requirement. DeviceNet Slave Fieldbus Card Version compatibility The module is Version 3 but may be used in existing Version 2 and Version 1 racks. It is designed to be used with the LCM-PLUS and firmware version 3.20 or higher. It is not possible to use the library with earlier versions of the firmware or with a simple LCM. Description The PC3000 DeviceNet Slave module provides one isolated communications channel. It can be used in any of the first five slots in a PC3000 main rack. More than one module can be mounted in the rack and the only limitation is that they must be mounted to the right (higher slot address) of any ICM, or other Lbus modules. The module comprises a motherboard that carries a plug-on COM-DNS DeviceNet. The motherboard provides:- · physical mounting for the module, connectors and diagnostics LEDs · power supply · Lbus interface to the DNS modules dual port memory Plug-on Hilscher COM Carrier card Lbus interface logic,