Eurotherm欧陆 LIN程序员编辑器用户指南.pdfVIP

LIN Programmer Editor User Guide HA029850 October 2011 (Issue 2) © 2011 All rights are strictly reserved. No part of this document may be reproduced, modified, or transmitted in any form by any means, nor may it be stored in a retrieval system other than for the purpose to act as an aid in operating the equipment to which the document relates, without prior written permission of the manufacturer. The manufacturer pursues a policy of continuous development and product improvement. The specifications in this document may therefore be changed without notice. The information in this document is given in good faith, but is intended for guidance only. The manufacturer will not accept responsibility for any losses arising from errors in this document. Programmer Editor User Guide Contents 1 Introduction 4 2 What is Setpoint Programming ? 5 What is a Setpoint ? 5 Setpoint Programming - Overview 6 Multi-Channel Program 7 Single Channel Program 8 What is a Program Template file ? 8 What is a Program file ? 8 3 Menus10 Menus 10 4 Program File Window 16 5 How to... 26 Configure a Program 26 Configure a Segment 28 Configure a Go Back Sequence 29 Configure a Holdback 30 Configure an Event31 Configure a User Value 32 Configure a Wait/Exit condition 33 Control a Program 34 Show the setpoint limits on the Chart 36 Configure the Program Template file37 6 Getting specific help 38 Open the Help File 38 HA 029 850