RockwellAutomation罗克韦尔Micrometer Adjustment Lever Arm for 802T Limit Switches Installation Instruction用户手册说明书.pdf

Installation Instructions Original Instructions Micrometer Adjustment Lever Arm for 802T Limit Switches Catalog Number 802T-W6 ATTENTION: To avoid electrical shock and/or unintended ATTENTION: Do not overtighten the clamp screw. A maximum operation of equipment, disconnect all power to the limit torque of 2.82 N•m (25 lb•in) is recommended. A 5/32 in. Hex switch and the controlled equipment before proceeding with key is used for both the clamp screw and the worm gear. any repair or adjustment of the limit switch. The micrometer adjustment lever arm (catalog number 802T-W6) is for use on 15° Adjustment Range rotary-operated Bulletin 802T limit switches. This lever arm allows for precise adjustment of the roller position with respect to the operating point of the switch. Lever Positioning Procedure Clamp Screw The location of the lever on the switch shaft determines preliminary positioning. To change the location: Worm Gear 1. Loosen the 3/8 in. nut. Nut 2. Move the lever to any desired position through 360° around the shaft. 3. Securely retighten the nut. Adjustment of the upper section of the lever accomplishes final positioning within a 15° arc. To adjust the upper section: 1. Loosen the clamp screw. 2. Turn the worm gear to desired position. 3. Retighte