机械专业英语试题及答案.docxVIP

机械专业英语试题及答案 题 号 一 二 三 四 五 六 七 八 总 分 得 分 C. degradation…corrosion D. corrosion… degradation 12. Most frames _______ cast iron, weld steel, composition, or concrete. A. are made from B. are made up of C. was produced by D. was consist of 13. Rotating shafts particularly those that run at high speeds, must be designed to avoid operation at speeds. A . low B .overload C. critical D. hollow 14. Although cast iron is a fairly cheap material, each casting requires a . A. pattern B. model C. mold D. patent 15. The term is used to describe joints with surface contact, as with a pin surrounded by a hole. A. high pair B. low pair C. surface pair D. rotary pair 二、完型填空（在每个小题四个备选答案中选出一个正确答案，本大题共15小题，每小题1分，总计15分） The term shaft usually refers to a relatively long member of round cross section that rotates and transmits power. One or more members such as gears, sprockets, pulleys, and cams are usually (16) to the shaft by means of pins, keys, splines, snap rings, and other devices. These latter members are among the “associated parts” considered in this text, as are couplings and universal joint, which serve to (17) the shaft to the source of power or load. A shaft can have a noround cross section, ant it need not necessarily rotate. It can be stationary and serve to (18) a rotating member, such as the short shafts that support the nondriving wheels of an automobile. The shafts supporting(19) gears can be either rotating or stationary depending on (20) the gear is attached to the shaft or supported by it through bearings. It is apparent that shafts can be subjected to various combinations of axial, bending, and(21) loads, and that these loads may be static or fluctuating. Typically, a rotating shaft transmitting power is (22) to a constant torque (producing a mean torsional stress) together with a completely reversed bending load (producing an