毕业设计（论文）-基于STM32单片机SPWM单相逆变电源设计.doc

题目：基于STM32单片机SPWM单相逆变电源设计 PAGE II PAGE II 摘要 随着科技的快速发展，近年来，越来越多的新能源被开发出来，为了使这些能源高效地被利用，提高输出电能的质量，人们不断改进这逆变电源。由于传统的逆变电源为采用了模拟控制，也就导致了整体结构的繁琐、抗干扰能力弱且难以调试的缺陷。相对而言数字化控制系统，结构简单、控制精准、便于调试的特点正利于逆变电源的发展。所以本文以社会生产实践出发，研究基于STM32单片机SPWM单相逆变电源，存在的实际的需求和价值。 首先文章引见了课题研究背景和目的，介绍了逆变电源发展及现状以及未来趋势。介绍了SPWM调制技术，对其两种控制进行了对比和根据要求选用。而后分为硬件设计和软件编写两部分实现，硬件部分主要讲述了逆变电源的主要结构组成，抉择了单相全桥逆变电路的构造，然后选用了STM32单片机作为主控芯片构建管理电路；软件部分描述集成开发环境Keil V5，分模块设计程序，然后对SPWM信号发生程序进行详解以及其他部分程序内容解析。 最后，在实验模块上进行调试，对调试方法加以说明。 关键词：逆变电源 软硬件设计 SPWM调制 STM32 Abstract With the rapid development of science and technology, in recent years, more and more new energy sources have been developed. In order to enable these energy sources to be used efficiently and improve the quality of the output power, people continue to improve this inverter power supply. Because the traditional inverter power supply adopts analog control, it leads to the defects of the cumbersome overall structure, weak anti-interference ability and difficult to debug. Relatively speaking, the characteristics of digital control system, simple structure, precise control and easy debugging are conducive to the development of inverter power supply. Therefore, based on the practice of social production, this article studies the actual demand and value of the SPWM single-phase inverter power supply based on STM32 microcontroller. First, the article introduces the research background and purpose of the subject, and introduces the development and current status of the inverter power supply and future trends. SPWM modulation technology is introduced, and its two controls are compared and selected according to requirements. Then it is divided into two parts: hardware design and software writing. The hardware part mainly describes the main structural composition of the inverter power supply, chooses the structure of the single-phase full-bridge inverter circuit, and then selects the STM32 microcontroller as the main control chip to build the management c