EMERSON艾默生 EHO Troubleshooting Guide说明书用户手册.pdf

TM Bettis Electro-Hydraulic Operator (EHO) Troubleshooting Guide Symptom Possible Cause Corrective Action Reference Material Incorrect voltage applied Apply correct voltage Refer to Wiring Diagram Incorrect terminals used Terminate on correct terminals Refer to Wiring Diagram Unit not powering on Fuses blown Replace Fuses Refer to Wiring Diagram Motor Control Module (MCM) failure Check MCM and replace if necessary Refer to Wiring Diagram due to wrong voltage applied Incorrect phasing Check that motor phase is correct Refer to Wiring Diagram Power on but motor not running Power supply insufficient Ensure proper power applied Refer to Wiring Diagram Field power wiring size is inadequate Apply proper power wiring Refer to Wiring Diagram Thermal overload tripped Reset thermal overload Power on but motor not running Local/Off/Auto switch in wrong position Set switch in Local and try again (locally) Actuator needs self calibration Run self calibration and try local commands again Video - 4.7 Self Cali