EMERSON艾默生 Manual Supplement Rosemount APEX and APEX Sentry-Installing the APEX Radar Gauge with Process Window说明书用户手册.pdf

Manual Supplement 00809-0300-4731, Rev AA August 2003 Rosemount APEX and APEX Sentry Installing the APEX Radar Gauge with Process Window Installing with a If you are installing the gauge with a process window, refer to Process Window Figure 1-1 on the reverse side of this document and follow these steps: NOTE Make sure the metal gaskets are installed and the flange bolts are torqued properly to keep moisture out of the spool piece. Bolts should be re-tightened 24 to 48 hours after initial installation. 1. Seat the process O-ring (7) into the groove on the window (6), and center the window on the process flange without letting the O-ring slip out of its position in the groove. 2. Make sure that the EMI gasket (8) is seated in the stainless steel window ring (5), place the window ring over the window, and center a spiral-wound gasket (4) over the window ring. 3. Center the standoff pipe or spool piece (2) on the flange. Put two of the bolts (9) in opposite sides and hand tighten. Look inside the spool piece to verify that the Teflon® window is centered on the flange. 4. Once the Teflon window is centered, use the rest of the mounting bolts and nuts to finish