EMERSON艾默生 Manual Mounting Instructions for DVC6200 DVC2000 Digital Valve Controller on (Old NAMUR) Sliding Stem Actuator Fisher说明书用户手册.pdf

DVC6200/DVC2000 Mounting Instructions Digital Valve Controller on D103997X012 (Old Namur) Sliding Stem Actuator May 2014 Use these instructions to mount a FIELDVUE™ DVC6200 or DVC2000. WARNING 1. Isolate the control valve from the process line pressure and release pressure from both sides of the valve body. Shut off all pressure lines to the actuator, Avoid personal injury or property releasing all pressure from the actuator. Use lock-out damage from sudden release of process procedures to be sure that the above measures stay in pressure or bursting of parts. Before effect while you work on the equipment. performing any maintenance 2. Install set screws into stem block. operations:  Always wear protective clothi ng, gloves, and eyewear.  Do not remove the actuator from the valve while the valve is still pressurized.  Disconnect any operating lines providing air pressure, electric power, or a control signal to the actuator. Be sure the actuator cannot suddenly open or close the valve.  Use bypass valves or completely shut off the process to isolate the valve from process pressure. Relieve process 3. Attach arm connector onto stem block set screws.