ABB Type SC, SC-1 Instantaneous Current and SV, SV-1Instantaneous Voltage Relays Instruction Leaflet 手册(英语)说明书.pdf

I.L. 41-766.1N SC, SC-1, SV and SV-1 Relay frame. The position of this shunt determines the pick- minal inserts. Lockwashers are assembled inside up setting of the relay. The lower end of the shunt is the molded terminal bushings between the inserts beveled and knurled, so that it can be grasped by the and the base, as a safeguard against loosening of fingers and turned to change the setting. A calibrated the screws. By rotating the bracket on its mounting scale plate is mounted adjacent to the shunt. A screw and moving it along its slot, the contact groove just above the knurl in the lower end of the assembly can be made either normally open or nor- shunt serves as an index mark, and the relay pick-up mally closed. The moving contacts are mounted on setting is indicated by the calibration scale marking a Micarta insulation plate which is secured to the which is adjacent to the groove. threaded end of the plunger shaft by a nut. The front edge of this insulation plate operates the indi- The construction of the plunger, core and flux shunt cator. The rear portion of the plate is slotted and a (which differ in details in the various types of these post screwed to the frame passes through this slot relays) causes the plunger to float in its energized to prevent the plate from rotating. The moving con- position, without being held against a stop, even tacts are double-faced so that they can be “make” when energized much above the pickup value. Con- or