ABB Power Break® II Mechanical Interlock for Stationary Breakers, 800-2000 A Frames - GEH6286 说明(英语)用户手册.pdf

1 GEH6286 INSTRUCTIONS • Power Break® II Circuit Breaker Accessories Mechanical Interlock for Stationary Breakers, 800-2000 A Frames Introduction The Mechanical Interlock accessory, catalog number SPWB20 and shown in Figure1, can be installed in 800-2000 ampere frame Power Break®II stationary circuit breakers. When two breakers in adjacent compartments are connected with an interlock rod, shown in Figure 2, this accessory prevents the simultaneous closing of both breakers. When either breaker is ON, the other will immediately trip if an attempt is made to turn it ON. When both breakers are OFF, either breaker may be turned ON. However, when one breaker is ON, an attempt to close the second breaker causes its closing springs to discharge without moving the contact arms. An override feature is provided in case of a race condition (both breakers turned ON simultaneously from OFF),so that the breaker designated as primary turns ON and the secondary breaker trips. Either or both circuit breakers may be CHARGED at any time, but the interlock operation activates only when one of the breakers is ON. — Figure 2 Mechanical Interlock attached to Power Break II circuit breakers in a switchboard. Installation WARNING: Before installing any accessories, turn the breaker off, disconnect it from all voltage sources, and discharge the closing springs.