ISO 62-2008 塑料吸水率的测定 英文版.docVIP

Reference number ISO 62:2008(E) . ISO 2008 INTERNATIONAL STANDARD ISO 62 Third edition 2008-02-15 Plastics . Determination of water absorption Plastiques . Détermination de labsorption deau ISO 62:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT . ISO 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@ Web Published in Switzerland ii . ISO 2008 . All rights reserved ISO 62:2008(E) . ISO 2008 . All rights reserved iii Contents Page Foreword iv Introduction v 1 Scope 1 2 Normative references 1 3 Principle 2 4 Apparatus 2 5 Test specimens 2 5.1 General 2 5.2 Square-shaped test specimens for homogeneous plastics 3 5.3 Test specimens of reinforced plastics affected by anisotropic diffusion effects 3 5.4 Tubular te