ABB Application Note - AC500 V3 EtherNet IP - AC500 as scanner connected to another AC500 as adapter 应用说明文档(英语).pdf

— APPLICATION NOT E AC500 V3 ETHERNET/IP AC500 AS SCANNER CONNECTED TO ANOTHER AC500 AS ADAPTER AC50 0 V3 E T HE RNET/IP AC50 0 AS S CANNE R CO NNE CTED TO A NOT HE R AC500 AS ADA PT E R Contents 1 Introduction 3 1.1 Scope of the document 3 1.2 Compatibility 3 1.3 Overview 3 2 Connect to AC500(-eCo) V3 4 2.1 Create AC500(-eCo) V3 EtherNet/IP Adapter 4 2.2 Data Setup for Implicit Messaging 6 2.3 EDS Export 8 2.4 Download the Project to EtherNet/IP Adapter 8 2.5 Create AC500 (-eCo) V3 EtherNet/IP Scanner12 2.6 Implicit messaging with AC500 (-eCo) V314 2.7 Download the Project to EtherNet/IP Scanner16 2 3ADR010969, 1, en_US AC50 0 V3 E T HE RNET/IP AC50 0 AS S CANNE R CO NNE CTED TO A NOT HE R AC500 AS ADA PT E R 1 Introduction 1.1 Scope of the document AC500 V3 PLCs support EtherNet/IP communication. This document describes how to con- figure the AC500 as scanner mode or adapter mode for EtherNet/IP communication. 1.2 Compatibility For this application the following modules and engineering system versions were used. It should also work with other versions, nevertheless some small adaptations may be necessary for future versions. • AC500 V3 PLC (PM56xx-2ETH) • AC500-eCo V3 PLC (PM5032-x-ETH, PM5052-x-ETH and PM5072-x-2ETH(W)) • Automation Builder 2.