ABB ABB Furse SPD - ESP KT KE Series data sheet 数据表(英语)说明书用户手册.pdf

— DATA SHEET Telecom computer line protection ESP KT KE Series Combined Category D, C, B tested protector (to BS EN 61643) suitable for use on ten line LSA-PLUS disconnection modules to PBX telephone exchanges, ISDN and other telecoms equipment with LSA-PLUS disconnection modules. For use at boundaries up to LPZ 0 to protect against flashover (typically the service entrance location) through to LPZ 3 to protect sensitive electronic equipment. Features benefits – Low cost protection for large numbers of data and signal – At larger installations ESP K10T1/2 and ESP K10T1/PTC lines provide all in one protection for all ten lines on LSA-PLUS – Very low let-through voltage (enhanced protection to disconnection modules IEC/BS EN 62305) between all lines - Full Mode protection – Use the ESP KE10 to provide trouble free earthing for – Full Mode design capable of handling partial lightning up to ten ESP KT1/2 and ESP KT1/PTC (per currents as well as allowing continual operation of disconnection module) protected equipment – ESP K10T1/2 and ESP K10T1/PTC have an integral earth – Repeated protection in lightning intense environments connection, and an external M4 earth bush for use with – Colour of housing distinguishes electrically different non-metallic LSA-Plus frames protectors - avoids confusion when installed together – ESP KT1/PTC and ESP K10T1/PTC have resettable on the same distribution frame overcurrent protection and are rated for power cross – Quick and easy plug-in installation, with ‘bump’ faults location feedback – ESP KT1, ESP KT1/PTC, ESP K10T1 and ESP K10T1/PT