Itron MLOG02 MLOG02 User Manual MLOG Logger Installation Guide说明书用户手册.pdf

MLOG Logger Installation Guide Flow Metrix, Inc. Revision 2.0 January 18, 2007 FCC ID: RIC-MLOG02 Flow Metrix, Inc. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Changes or modifications not expressly approved by the party responsible for compliance co uld void the user’s authority to operate the device. MLOG loggers are installed on water service pipes, typically near the meter on the side of the water main, not the consumer. The logger is housed in a plastic waterproof enclosure. All electronics, including the vibration sensor, processor, timer, digital radio, and antenna are sealed inside the unit. Permanent installation requires no tools and takes less than a minute. The MLOG logger is attached directly to the pipe using one (1) buna O-ring, as shown to the left or one cable tie, as shown on the right. An O-ring is looped around each of the O- ring tags molded onto the side of the unit. The cable tie is passed unde